High-pressure blowers

Outline of 60DCF

Part names

Terminal Block	No.1	FG	Connector(SIGNAL)	No.1	S_CTR
	No.2	ACL		No.2	CTR_GND
	No.3	ACN		No.3	FOLT
				No.4	FOLT_GND
Connector(SENSOR)	Sensor Connector Input of Blower		Connector(MOTOR)	Motor Connector Input of Blower

If terminal block is placed near the Blower, make sure vibration / air stream does not cause mechanical fatigue of wire.
Fixed attachment to a nylon clamp and/or duct is recommended.
Driver connection to an AC power supply input terminal block should be firmly fixed using a crimp-type terminal with an insulating cover. (Recommendation: RAV 1.25 - 4, JISC2805 compliance） and electric wire equivalent to or larger than 1.25 mm².
Make sure connector is pushed all the way down.

The Blower output can be adjusted by adjusting The input voltage between The control I/O connector terminal S_CTR and The CTR_GND terminal.
Input voltage: 0 V DC to 10 V DC, Input current: 1 mA or less
Please input the DC voltage that meets the input voltage specification between the terminal S_CTR and the terminal CTR_GND.

For product-related inquiries, please contact us using the form below.